Symbol Engine

I finally had the time to try out Spaceman Spiff's Color Fix on my DTV. So I took my DTV apart , heated my soldering iron and tried to focus my eyes on the teeny weeny resistors. First let me tell you this: Piggybacking Surface mounted resistors is NO PICNIC.

You need completely steady hands, eagle eyes or a stereo microscope, a really good tweezer to grip the tiny resistors, a soldering iron with heat control and a good quality soldering& paste flux. I had& none of them. After 2 hours of agony I could only solder one (1) resistor into place. Then when I accidentally touched the one I soldered when I was trying my luck on the second one, the first one came off… Complete with the original resistor on the DTV board. Talk about pain.

I left everything on the table and fired up my a1200 to normalize the levels of stress hormones in my blood.

The other day I decided it would be much easier to take the original resistors out and solder new ones in than to try to piggyback them. And here it is, the turning point:

Spiff's page says these resistors should ideally be 165 ohms. What I had in hand was the 220 ohms resistors I prepared for the easy fix. The ones on the board where 680 ohms, so I decided to try my luck. 220 ohms is much closer to the ideal value than 680. I soldered them in and as I thought it was much easier.

The result is as anyone can guess, not as good as the original fix, but is much better than the original buggy board. It would have been much better if I had resistor with a closer value to 165 ohm. So I dub this fix Half a Spaceman Spiff's Ghetto Color Fix, or HaSSGCF.

So the moral of the story boys and girls is, it's much easier to replace SMD's than to solder them piggybacked if you don't have right tools.

Popularity: 78% [?]